sunjoe SPX3500 - Page 8

8
4. Slide the trigger gun holder in position (Fig. 4).
5. To assemble the spray wand protector, rst snap the tab
into the slot located at the bottom left side of the unit, and
then secure it in place with one 4.8 x 16 screw (Fig. 5).
6. Fit the spray wand into the trigger gun and rotate it until
the two parts are completely locked (Fig. 6).
7. Connect the high-pressure hose to the trigger gun (Fig. 7).
8. Connect the other end of high-pressure hose to the water
outlet on the washer (Fig. 8).
Fig. 3
Nozzle
storage board
Fix with 4.8
x 16 screws
Fig. 4
Trigger gun holder
Fig. 5
Tab
Slot
4.8 x 16 screw
Fig. 6
Spray wand
Trigger gun
High-pressure hose
Trigger gun
Fig. 7