sunjoe TRJ13STE - Edging

10
1. Hold the trimmer at an angle of approximately 10 – 30
degrees to the work area (Fig. 16).
2. Slowly swing the trimmer from side to side (Fig. 17).
3. Do not overload your trimmer; instead, take small “bites”
of grass, working from the top to the bottom. This will
keep the machine operating at high speed and will greatly
improve its cutting eciency (Fig. 18).
Edging
1. To convert for maintenance edging, turn OFF and unplug
the tool.
2. To use the edger guide + ower guard, ip it down from its
stored position (Fig. 19).
3. Pull up edging coupler and turn the rear handle
counterclockwise and release (Fig. 20). The tool is locked
in edger mode.
10° – 30°
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Edger guide +
ower guard
Fig. 20
Pull up edging
coupler to
rotate
Rear
handle