sunjoe TRJ13STE - Winding the Line; Storage; Service and Support; Model and Serial Numbers

1. Unplug the grass trimmer.
2. To remove the spool from the trimmer hub, follow steps
1 and 2 from the section "Replacing the Spool + Clearing
Jams and Tangled Lines" beginning on page 12.
3. Find the middle of a new piece of 0.063 inch nylon line (up
to 16 feet total with 8 feet on both ends), and insert the
middle of the line into the groove in the center of the spool
(Fig. 27).
4. Wind both ends into the grooves using slight tension and
following the direction of the arrows (Fig. 28).
5. Re-install the spool as instructed in steps 4 to 7 of
"Replacing the Spool + Clearing Jams and Tangled Lines".
mCAUTION! Catapulted pieces of nylon line may cause
injury.
NOTE: The maximum recommended length of line in the spool
is 16.4 ft (5 m), with 8 ft (2.5 m) per slot.
mWARNING! Pay attention to the winding direction.
NOTE: Always replace the spool with a new pre-wound spool.
Visit snowjoe.com to purchase the pre-wound spool
(model TRJ13STERS) for this electric trimmer + edger.
IMPORTANT: Keep all areas of the cutting head and cutting
head cover clean. Place the cap back by pushing it rmly
onto the cutting head. To ensure that the cutting head cover
is correctly tted, try to remove it without depressing the two
latches. If it is correctly tted, it should not move.
Storage
Follow these recommendations for storing the trimmer.
• Clean the trimmer + edger thoroughly before storing.
• Store the trimmer + edger in a stable and safe position out
of the reach of children. Keep the trimmer in a dry place
where the temperature is not too hot or too cold.
• When storing the trimmer + edger, do not rest it against the
oor. Hang it by the upper handgrip so that the guard does
not touch anything. If the guard rests against a surface, its
shape and dimensions could be permanently altered, and
could render the machine unsafe to use.
Service and Support
If your Sun Joe
®
Trimmer Joe TRJ13STE electric grass trimmer
+ edger requires service or maintenance, please call the
Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563).
Model and Serial Numbers
When contacting the company, reordering parts, or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the decal
located on the housing of the unit. Copy these numbers into
the space provided below.
Fig. 27
Groove
Fig. 28
Record the following numbers from the housing or handle of your
new product:
Model #:
Serial #:
T R J 1 3 S T E
13