Sunlighten Community User Manual

OPERATING INSTRUCTIONS
WARM UP TIME & USAGE GUIDELINES
Our saunas are based on the infrared wavelength and not cabin temperature.
The following steps and hints are provided for your optimum usage:
STEP 1: Make sure your sauna is plugged into a dedicated circuit installed by
  yourelectrician.Whenturningsaunaonforthersttime,ensureeachheater
is active after a couple of minutes. If they are not, make sure connections are
securely paired from their initial wire feed coming from the power box under
the bench.
STEP 2: If not using a pre-set wellness program, set the desired temperature and
set time to 60 minutes.
STEP 3: Whenturningsaunaonforthersttime,ensureeachheaterisactiveaftera
couple of minutes. If they are not, make sure connections are securely paired
from their initial wire feed coming from the power box under the bench.
We recommend you enter the sauna at a lower temperature (eg: 40°C) than
your desired highest temperature (eg: 58°C). This will ensure a constant
emmission of infrared from the heaters.
STEP 4: Neverfullycovertheoorgrateandheaterwithanyobstructionthatwillnot
allow the heater to dissipate its heat.
TIPS FOR OPTIMAL USE
•
Sauna requires a dedicated circuit and outlet for optimal performance.
 Thisshouldbeinstalledbyacertiedelectricianbeforeassembling.
•
Use our Tri-Nature Cleaning products for periodic cleaning.
Available at https://shop.sunlighten.com.au/collections/natural-sauna-cleaners
•
 Ensureyoucleanyouroorheaterevery6monthsforresidentialuse,andevery
 monthforcommercialuse.Toclean,removeoorgrateandvacuumoutheaterarea.
24

Sunlighten Community Specifications

General

Brand	Sunlighten
Model	Community
Category	Plumbing Product
Language	English