ASSEMBLY
Can I assemble my sauna outdoors?
Yes, if you protect it with a Sunlighten canvas, sauna cover. If you place your sauna
outdoors without a Sunlighten cover, your warranty will be void.
The sauna covers
are custom made and may not arrive until after you receive your sauna. Do not install
your sauna outdoors prior to receiving your cover. Doing so will void the warranty!
Check the sauna cover annually for normal wear and replace as needed.
Sauna cover manufacturer warranty is one year.
How much room is required around my sauna for setup & maintenance?
We recommend 15cm of clearance around the back and sides and 30cm above the top
of the sauna to access plugs and for general maintenance. Leave at least 15cm
behind the unit to allow the electronics to cool.
What surfaces can I set my sauna on?
You can set your sauna on tile, concrete, carpet, laminate or wood.
Always have your
sauna feet installed.
Remember to make sure that your sauna is level regardless of its
location for optimal use. If your sauna is placed outdoors, make sure there is adequate
drainage so that water cannot pool around the base of the sauna. If placed near or on
coolsurfaces(likeconcreteandbasementoors),warm-upcanbeimpacted.
How do I install Chromotherapy and Acoustic Resonance Therapy?
Sauna accessories have separate user manuals. Refer to the appropriate manual:
http://www.sunlighten.com/customer-care/
How do I disassemble if I need to move the sauna?
Refer to assembly sheet and follow the steps in reverse.
USAGE
How long does it take for my sauna to warm up?
The controls are preset to 60 minutes at 70°C. However, the inside cabin temperature
is not intended to reach this. Our saunas are based on the infrared wavelength and not
cabin temperature. Allow the sauna to warm up for a minimum of 15 minutes. If located
outside or in unheated garage, additional warm-up time may be required. If you prefer
the sauna hotter, let it warm up longer.
FAQS
29
To Next Page
Loading...
Need help?
General
