Sunlighten Community User Manual

TROUBLESHOOTING
ISSUE SOLUTION
An electrical
component is
not working after
assembling
Sauna does not
power ON
Slow
warmup time
Heat is not coming
from all walls
A.R.T. doesn’t work
Speaker feedback
(high-pitched buzz)
when using sound
from media apps
Check all connections - see pg. 11. A newly assembled unit with a non-
functioning electrical component (control panel, heater panels, lights,speakers)
will most likely have a missed or loose connection.
First,besuretoholdthePowerbuttonfor10secondstoturnon.Conrmthat
the voltage & amperage coming from the outlet is correct for your model (see
pg.4).Checkthattheoutletisonadedicatedcircuit.Oncevoltageisveried
at the outlet, check the voltage at these three points:
1. Exterior power cord before the receptacle in the base. If there is no
voltage the exterior power cord needs to be replaced.
2. If the exterior power cord is getting voltage check the voltage going to the
receptacle (to check, unscrew the 2 screws holding the receptacle to the
base. If there is no voltage reading at the receptacle, then the receptacle
needs to be replaced.
3. If voltage is going to the receptacle, check the voltage at the interior power
cord going to the power control box (PCB). If voltage is still reading there
the issue is most likely a faulty PCB. If there is no voltage reading at the
interior power cord, the interior power cord needs to be replaced.
Ensure each wall panel is heating and that you have the CORRECT electrical
specs on a DEDICATED CIRCUIT - see pg 4. Check that the temperature and
time is turned all the way up. If those are correct:
1. Check if the breaker switch is tripped on the back right corner of the (PCB).
If the breaker is tripped, simply press the breaker switch button back in to
 xthisissue.Ifthebreakerswitchkeepstripping,thenreplacethebreaker 
switch for the PCB.
2. Check for heat output from all heaters in the unit.
3. Verify wall & heater connections.
Check that all connections are made at the base and corresponding panel —
see pg. 11.
The Fader setting (front/back balance) must be adjusted in the stereo.
The control panel is connected to the speakers through the stereo. If the stereo
volume is turned up past 25, it will cause a high-pitched interfer-ence through
the speakers. Turn stereo volume down to 25 or lower. Ad-just volume through
the media app on the control panel. Check wiring and separate within walls —
make sure there is space between wires to avoid feedback.
34

Sunlighten Community Specifications

General

Brand	Sunlighten
Model	Community
Category	Plumbing Product
Language	English