What to do if Sunquest Personal Care Products lamps fail to light?
If the lamps in your Sunquest Personal Care Products unit fail to light, first check the AC power source and reset the circuit breaker or replace the fuse if needed. Ensure the unit is properly plugged into the outlet and that the cord connecting the canopy and bench is securely connected. Also, verify that the timer dial is set to a number greater than 0.
What to do if Sunquest Personal Care Products sunbed does not stay lit?
If your Sunquest Personal Care Products sunbed does not stay lit, begin by checking the AC power source. Reset the circuit breaker or replace the fuse if necessary. You may also check the timer system.
What to do if one or more lamps fail to light in Sunquest Personal Care Products?
If one or more lamps in your Sunquest Personal Care Products unit fail to light, first ensure that each lamp is correctly installed. Try switching an unlit lamp with one that is working. If the new lamp lights up and the old one still doesn't, then replace the old lamp.
Why does the canopy fail to stay in position on Sunquest Personal Care Products?
The gas springs should hold the canopy fully open or allow it to rest fully closed. It's normal for the canopy to creep down if left open for a long time. Keep the canopy closed when not in use. When the gas springs no longer hold the canopy open, replace them.
General| Brand | Sunquest |
|---|---|
| Model | PRO 24RS |
| Category | Personal Care Products |
| Language | English |
To Next Page
