What to do if Sunquest Personal Care Products lamps fail to light?
If the lamps in your Sunquest Personal Care Products unit fail to light, first check the AC power source and reset the circuit breaker or replace the fuse if needed. Ensure the unit is properly plugged into the outlet and that the cord connecting the canopy and bench is securely connected. Also, verify that the timer dial is set to a number greater than 0.
What to do if Sunquest Personal Care Products sunbed does not stay lit?
If your Sunquest Personal Care Products sunbed does not stay lit, begin by checking the AC power source. Reset the circuit breaker or replace the fuse if necessary. You may also check the timer system.
What to do if one or more lamps fail to light in Sunquest Personal Care Products?
If one or more lamps in your Sunquest Personal Care Products unit fail to light, first ensure that each lamp is correctly installed. Try switching an unlit lamp with one that is working. If the new lamp lights up and the old one still doesn't, then replace the old lamp.
Why does the canopy fail to stay in position on Sunquest Personal Care Products?
The gas springs should hold the canopy fully open or allow it to rest fully closed. It's normal for the canopy to creep down if left open for a long time. Keep the canopy closed when not in use. When the gas springs no longer hold the canopy open, replace them.
Inspect unit for damage and record serial numbers upon delivery.
Consider electrical needs, room environment, and required assembly assistance.
Step-by-step guide for assembling the sunbed, including attaching legs and brackets.
Connect power cord to the bench and plug into a suitable dedicated electrical outlet.
Precautions for skin prep, hair products, and general usage guidelines before tanning.
Recommended tanning durations based on skin type and session number for optimal results.
Instructions on using the parental lock switch to monitor unit usage by children.
Guide on operating the sunbed, activating face tanner, setting the timer, and cool-down.
Procedures for cleaning the tanning bed's bench and canopy with appropriate disinfectants.
Instructions for deep cleaning to remove dust and maintain tanning effectiveness.
Guidance on when and how to safely replace tanning lamps and lamp starters.
How to check the operation and accuracy of the primary and backup shut-off timers.
Solutions for issues where the tanning lamps do not illuminate properly.
Steps to diagnose and fix problems with individual tanning lamps not working.
How to address canopy position issues, likely related to gas springs.
Troubleshooting steps if the sunbed unexpectedly turns off during operation.
General| Brand | Sunquest |
|---|---|
| Model | PRO 26RS |
| Category | Personal Care Products |
| Language | English |
To Next Page
