26525-01A
11
Using Your Sunbed
Once you have read Before You Tan and
Exposure Times, you are ready to use your
sunbed. Proceed as follows.
Your sunbed is designed for individual
use. Always wear the safety goggles sup-
plied with your sunbed or another
approved pair of goggles, as defined
under 21 CFR 1040.20. Regular sunglass-
es do not provide adequate protection
from ultraviolet light.
Step 1 For units equipped with a face
tanner, activate the face tanner
by placing the rocker switch,
located below the timer knob,
into the “I” (ON) position. If you
do not wish to use the face tan-
ner, leave the switch in the ”O”
(OFF) position. NOTE! The F
model face tanner lamps require
a cooling period before they
will light again.
Step 2 Put on your goggles. Set the
timer to the desired number of
minutes (after first determining
the proper time period from the
table in Exposure Times). The
lamps will turn on as soon as
you move the rotary dial past
the “0” position.
Step 3 Lift the canopy, lie down on the
bench (face up), and lower the
canopy toward your body, main-
taining minimum distances as
described in Safety Information.
Step 4 When the timer reaches 0, the
lamps will automatically turn off
and the cooling fans will run for
approximately 3 minutes during
the “Cool Down” period.
WARNING
Wear protective eyewear.
Failure to may result in severe burns or
longterm injury to the eyes.
Operation - Using Your Sunbed
To Next Page
Loading...
