10
3) Lubrication
Before using the machine, be sure to supply a sufficient amount
of oil through the lubrication hole marked with red color. Pour
oil into the arm lubrication tank ① and bed lubrication tank ②
to the red line. Check lubrication once a day.
Oil supply adjustment of the hook
Use the screw ③ on the right side of the bed lubrication tank ②
to adjust the amount of oil supply. Turn the screw ③ to the right
(＋) to increase the oil supply, and to the left (－) to decrease the
oil supply.
[ Figure 3 ]
①
[ Figure 4 ]
Oil tank
②
③
2) Installation of head enclosures
Insert the head hinge ① into the bed hole and align it well with the head hinge rubber ② of the table. Place the machine on
the head support rubber ③.
[ Figure 2 ]
①
②
③
To Next Page
