15
[Figure 19]
10) Reverse button function
(automatic thread trimmer)
Pressing the back tack button or reverse button ① during
forward sewing will start reverse sewing immediately.
When you stop the machine and restart it by stepping down
on the pedal with the reverse button ① already pressed
down, you can perform reverse sewing from the beginning.
When the machine is in a “stop”mode, you can change the
up-down position of the needle bar by pressing the reverse
button. Lightly pressing the button once when the needle is
in a down-stop position will stop the needle bar in a high
position. Pressing the reverse button twice within less than
a second when it is in an up-stop position will stop the
needle bar in a low position. In short, the button delivers
two functions: one for reverse sewing and the other for
converting vertical position of the needle. (See Figure 19.)
MEMO
To Next Page
Loading...
