SunStar SPS/A-Pattern Series - Page 101

101
D. Input the speed of main shaft and distance of
transfer, then press ENTER key. If you
want to test with the factory-installed setting
value, just press ENTER key. You can see
the beginning angle of upper shaft transfer,
turning times of upper shaft and number of
stitches. Drive the step motor and main shaft
motor SPM/10times, then finish the step motor-
main shaft motor test automatically.
E. If you want to finish test menu, press ESC key.
Press ESC one more time to back to the initial
screen.
A. Press MODE key.
B.
After moving to “4. Machine Test” by using
direction keys , press ENTER key.
C. After moving to “2. Main Motor Test”by using
direction keys , press ENTER key.
D. Upper feed plate comes to descend.
Press ENTER key. If you want to change
the speed of main shaft, press SPEED key.
E.
If you want to finish main shaft motor test,
press ESC key.
If you want to finish test menu, press ESC key.
F. Back to the initial screen by pressing ESC key.
X-Y-Main Motor
Test.....
SPM:0200
dx:020 dy:020
Start = 00240
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
<< Test Menu >>
2.MainMotorTest
3.InterruptTest
4.PWM Test
PEDAL START
Speed = 0200
1-3) Main Motor Test
It is to test if the main shaft motor operates properly.