SunStar SPS/A-Pattern Series - Page 106

106
D. : Air pressure error (normal: 1)
: New I/O Board (0)
: Direct connection type (0)
: Communication between main shaft
board and main shaft motor (0), if
direct connection is used.
: If IO Board is number 21, (0).
: If OP is old, it is set at (1). If OP is new, it is set at (0).
: Not in use
IP26,27
NEWOP
IOB21
ASYNC
DIRECT
BDNEW
LOWPR
C. Move to “9. Input2 Test” by pressing
keys and press key.
ENTER
direction
LOWPR 1 BDNEW 0
DIRECT 0 ASYNC 0
IOB21 0 NEWOP 1
IP26 1 IP27 0
E. Press key to end Input 2 Test. Press key to end Test Menu.
ESCESC
F. Press key to return to the initial page.
ESC
1-10) Input 2 Test
This function can be used to check whether, of the input signals, air pressure input signals and inputs
related to direct connection are working properly.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
A. Press key.
MODE
1-11) Input 3 Test
This function is to test whether or not each input signal is working properly.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
A. Press key.
MODE
B. Move to “4. Machine Test”by pressing
keys and press key.
ENTER
direction
<< Test Menu >>
9. Input2 Test
10. Input3 Test
11. Input4 Test
B. Move to “4. Machine Test”by pressing
keys and press key.
ENTER
direction
C. Move to “ ” by using
keys and press key.
ENTER
direction
10.Input3 Test
<< Test Menu >>
10. Input3 Test
11. Input4 Test
12. Input5 Test