SunStar SPS/A-Pattern Series - Page 107

107
D. Now Input3 is not in use.
IP30 1 IP31 1
IP32 1 IP33 1
IP34 1 IP35 1
IP36 1 IP37 1
E. To end Input3 Test, press . To end Test Menu, press .
ESCESC
F. Return to the initial screen by pressing .
ESC
C. Move to “ ” by using
keys and press key.
ENTER
direction
11.Input4 Test
D. : Error signal of Y shaft Servo Motor
(Normal: 1)
: Error signal of X shaft Servo Motor
(Normal: 1)
Other Input ports are not in use.
XMErr
YMErr
YMErr 1 XMErr 1
IP42 1 IP43 1
IP44 1 IP45 1
IP46 1 IP47 1
E. To end Input 4 Test, press . To end Test Menu, press .
ESCESC
F. Return to the initial screen by pressing .
ESC
1-12) Input 4 Test [only applied for SPS/C-Series]
This is used to check whether or not X-Y Motor Error input signal is working properly.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
A. Press key.
MODE
<< Test Menu >>
11. Input4 Test
12. Input5 Test
13. Input6 Test
B. Move to “4 Machine Test” by using
keys and press key.
ENTER
direction
1-13) Input 5 Test [only applied for SPS/C-Series]
This function can be used to check whether or not each input signal is working properly.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
A. Press key
MODE
B. Move to “4. Machine Test” by pressing
keys and press key.
ENTER
direction