SunStar SPS/A-Pattern Series - Page 108

108
C. Move to “ ” by pressing
keys and press key.
ENTER
direction
12.Input5 Test
D. Input 5 is not in use.
DIP10 1 DIP11 1
DIP12 1 DIP13 1
DIP14 1 DIP15 1
DIP16 1 DIP17 1
E. Press key to end Input 5 Test. Press key to end Test Menu.
ESCESC
F. Press key to return to initial page.
ESC
<< Test Menu >>
12. Input5 Test
13. Input6 Test
14.Encoder1 Test
C. Move to “ ” by pressing
keys and press key.
ENTER
direction
13.Input6 Test
D. : Check whether or not detecting signal from
lower motor sync.
: Detect unusual signal related lower motor
shaft (Normal: 1)
Other Input signals are used.
MErr1
Sync1
Sync1 1 MErr1 1
IP62 1 IP63 1
IP64 1 IP65 1
IP66 1 IP67 1
1-14) Input 6 Test [only applied for SPS/C-Series]
This function can be used to check whether or not lower shaft motor input signal is working properly.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
A. Press key.
MODE
<< Test Menu >>
13. Input6 Test
14.Encoder1 Test
15.Solenoid Test
B. Move to “4. Machine Test” by pressing
keys and press key.
ENTER
direction
E. To end Input 6 Test, press . To end Test Menu, press
ESCESC
F. Return to the initial screen by pressing .
ESC