SunStar SPS/A-Pattern Series - Parameter Settings for General Sewing

115
DESCRIPTION ON PARAMETER RELATED TO
GENERAL SEWING OPERATION
※ The order can be different depending on SPS/A/B/C-Series.
※ The shadow area indicates factory-installed condition.
Function No. : 000
Function Name : Manual Operation En/Dis
It is to set moving of feed plate manually by using direction keys.
It is impossible for feed plate to move by using direction keys.
[ Contents ] It is impossible to make the feed plate move manually by using direction
keys in the sewing available mode.
[ Caution ] It is possible to make the feed plate move manually by using direction
keys without having relation to setup, under the condition of pattern
programming.
It you set up for Disable, you cant use the Function No 001Moving to
start position/the 2nd origin by manual drive.
000. Jog En/Dis
1) DISABLE
Setting
Value
It is possible to make the feed plate move by using direction keys. (Factory installed condition)
[ Contents ] It is possible to make the feed plate move manually by using direction
keys in the sewing available mode.
[ Caution ] It is only possible when upper feed plate is down.
2) ENABLE
66