114
E. At the moment the key is pressed, the main shaft will turn one time. And it will show
“ ”on the LCD characters.
MotorRun
ENTER
When you will press the key continually as above, the main shaft motor will turn one time.
Therefore, to progress such movements signifies to go on the
normally.
(This function is applied only for the .)
direct type motors, for reference
and the I/O board
communication between the main shaft board
ENTER
F. Press key to end Test Menu.
ESC
G. Press key to return to initial page.
ESC
D. Initial speed setting value has been set up by ,
it is shown by “”. Press
key.
ENTER
MotorStop
100
Async. Test
Speed = 100
MotorStop
C. Move to “ ” by pressing
keys and press key.
ENTER
direction
25.Async Test
<< Test Menu >>
26.Async Test
To Next Page
Loading...
