113
C. Move to “ ” by pressing
keys and press key.
ENTER
direction
24.Jump Test
D. Input the time for repeating Jump transfer distance
of XY and press key. Just press
key to conduct test with the factory-
installed setting value.
ENTER
ENTER
X-Y Jump Test
Delay : 0007[ms]
jmp_dx : 0020
jmp_dy : 0020
E. Press key to end Test Menu.
ESC
F. Return to the initial screen by pressing key.
ESC
<< Test Menu >>
24.Jump Test
25.MotorType Test
26.Async Test
1-23) Communication Test between the Main Shaft Board and the CPU/IO Board (Async Test)
The communication function with the main shaft driver has been added to set up the phase stopping
position as parameter in the direct models. The test shall be done according to the following procedure.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
A. Press key.
MODE
B. Move to “4. Machine Test” by pressing
keys and press key.
ENTER
direction
1-22) Jump Test
This is used to check whether or not XY step motor is working properly and do jump test.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
A. Press key.
MODE
B. Move to “4 Machine Test” by using
keys and press key.
ENTER
direction
D. Pressing any key will go to original point and
original test automatically.
Origin Test.
Press AnyKey
E. To end test menu, press key.
ESC
F. Return to the initial screen by pressing key.
ESC
To Next Page
Loading...
