SunStar SPS/A-Pattern Series - Page 123

123
Function No. : 014 5
th
Needle Speed Setting
Function No. : 015 6
th
Needle Speed Setting
Function No. : 016 7
th
Needle Speed Setting
User sets the speed for the 7
th
needle.
User sets the speed for the 7
th
needle (default value: 12[100ms])
[ Contents ] This function is used when the set value of Parameter "009. Slow Start Main
Shaft Acceleration" is "7) User Define."
016. USER_SLOW_7
2~25[100ms]
Setting
Value
User sets the speed for the 6
th
needle.
User sets the speed for the 6
th
needle (default value: 10[100ms])
[ Contents ] This function is used when the set value of Parameter "009. Slow Start Main
Shaft Acceleration" is "7) User Define."
015. USER_SLOW_6
2~25[100ms]
Setting
Value
User sets the speed for the 5
th
needle.
User sets the speed for the 5
th
needle (default value: 8[100ms])
[ Contents ] This function is used when the set value of Parameter "009. Slow Start Main
Shaft Acceleration" is "7) User Define."
014. USER_SLOW_5
2~25[100ms]
Setting
Value
Function No. : 017 8
th
Needle Speed Setting
User sets the speed for the 8
th
needle.
User sets the speed for the 8
th
needle (default value: 14[100ms])
[ Contents ] This function is used when the set value of Parameter "009. Slow Start Main
Shaft Acceleration" is "7) User Define."
017. USER_SLOW_8
2~25[100ms]
Setting
Value