SunStar SPS/A-Pattern Series - Page 124

124
Function No. : 018 9
th
Needle Speed Setting
Function No. : 019 10
th
Needle Speed Setting
User sets the speed for the 10
th
needle.
User sets the speed for the 10
th
needle (default value: 18[100ms])
[ Contents ] This function is used when the set value of Parameter "009. Slow Start Main
Shaft Acceleration" is "7) User Define."
019. USER_SLOW_10
2~25[100ms]
Setting
Value
User sets the speed for the 9
th
needle.
User sets the speed for the 9
th
needle (default value: 16[100ms])
[ Contents ] This function is used when the set value of Parameter "009. Slow Start Main
Shaft Acceleration" is "7) User Define."
018. USER_SLOW_9
2~25[100ms]
Setting
Value