162
Function No. : 108 Function Name: Needle cooling off-time cycle setting (applicable to SPS/C-Series only)
It sets the needle cooling off-time cycle.
It sets the needle cooling off-time cycle (default value: 5[s]).
[Description] During the set time, cold air is not sprayed into the needle. To enable this function,
"
2)TIMER
"
should be selected in
"
11 NeedleCoolSet.
"
108. NeedleOffTime
00~100(1sec)
Setting
Value
Function No. : 109 Function Name: Setting Up pneumatic thread trimming entry angle
The function that users setup the entry angle of the pneumatic thread trimming device
This does not apply to cam thread trimming method.
The proper entry angle gap of thread trimming can happen due to the nature of the equipments or
the sewing materials.
Users can adjust the entry angle of thread trimming knife with the existing parameter.
[Contents] The most stable thread trimming angle is usually between 20 and 40.
109. Trim St Angle
00~50
ㅇ
Setting
Value
- Highest needle bar point
- Lowest needle bar point
- Entry angle of upper
thread holder
{
- Entry angle of thread trimming {
To Next Page
Loading...
