SunStar SPS/A-Pattern Series - Page 163

163
Function No. : 111 Function Name: Setting of the needle bar stop position
It halts the needle bar at the set value when the motor stops. (applicable to the direct drive motor models)
The value can be set at the range of 0 ~ 360
ㅇ
. (default value: 0
ㅇ
But, in case of SPS/C-Series,
the default value is 97
ㅇ
[Description]
The needle bar position angle can be changed as follows: Turn the hand pulley clockwise and then you
can notice the change in angle. At the changed position, press ENTER to set the current value. In case
of SPS/C-Series, however, due to the mechanical feature, the head is lifted up and the main shaft motor
position is changed to 90
ㅇ
. Therefore, in case of SPS/C-Series, the default value is 97
ㅇ
.
111. Upstop Pos
0

~360

Setting
Value
Function No. : 110 Function Name : Set up the entry angle of pneumatic upper thread holder.
A user can set the entry angle of the pneumatic upper thread holder.
A user can adjust the motion angle of the upper thread holder after setting the trimmer entry angle.
[Contents] Normally, the upper holder device angle should start moving 40° to 60° behind the
user-set trimmer entry angle. Then the appropriate amount of thread (4-6cm)
remains at the thread.
110. Thrd Hold Angle
0°~100°
Setting
Value
Highest position of the needle bar
Entry angle of the upper
thread holder
Trimmer entry angle
Lowest position of the needle bar

