171
NO. Function name Contents
Explanation and factory-installed setting value
Unit
0/1
Emergency stop setting during jump
105
500[ms]
1) DISABLE
2) ENABLE
Upper thread holder setting
(C-Series AIR BAG model)
098
The upper thread holder function is not used.
The upper thread holder function is used.
1
Upper thread holder time setting
099
It sets the time of holding the remaining needle thread after
trimming by the upper thread holder.(0~5)
1) DISABLE
2) ENABLE
Clamp sensor setting
(C-Series AIR BAG model)
100
The clamp sensor is disabled.
The clamp sensor is enabled.
1) DISABLE
2) ENABLE
Airbag mode setting
101
The regular clamp is used.
The removable (Cassette type) clamp is used.
1) DISABLE
2) ENABLE
0/1
Program mode lock
102
1) Disabled
2) Enabled
1) DISABLE
2) ENABLE
0/1
Semi-automatic removal of lower
feed plate
103
1) Disabled
2) Enabled
1) Ref_UP
2) Ref_DN
0/1
Setting of basic clamp position
104
1) Disabled
2) Enabled
Needle cooling function setting
Needle cooling time setting
Needle cooling off time cycle
setting
Setting of the pneumatic trimmer
entry angle
106
107
108
109
1) NORMAL
2) TIMER
3) DISABLE
The needle cooling function is on during
sewing.
The needle cooling takes place in the
manner set by the user.
The function is not used.
4
5
30
It sets the time of releasing cold air to cool
off the needle (000~100ms).
It sets the needle cooling off-time cycle.
Adjust the entry angle of pneumatic thread
trimming.
1[ms
]
1[ms
]
1[
]
Setting of the upper thread
holder angle
110
55
It sets the angle of holding the needle by the
thread holder after trimming (1~100
).
1[
]
Setting of the needle bar stop
position
111
0
(in case of SPS/C-Series, 97)
The motor stops at the set value
(000~360 x [
]
)
1[
]
1) Ref_UP
2) Ref_DN
1) Disabled
2) Enabled
To Next Page
Loading...
