SunStar SPS/A-Pattern Series - Page 184

184
Description：This is a function to call designs automatically. A total of 15 designs can be automatically called by using the
four input sensors. It can be controlled by external inputs such as sewing start, emergency switch, clamp, and the enter key.
▶ In order to use the Auto Call function from SPS/A/B-Series, the existing I/O Board should be replaced with the I/O
Board of SPS/C-Series. Otherwise, the function is unavailable.
1-1) Signal information related to input port connection
How to Use AUTO CALL (For SPS/A/B-Series)
 External sensor's input signal list-up for design auto call
NO. SEN_3 SEN_2 SEN_1 SEN_0 Design Number
1 0 0 0 1 900
2 0 0 1 0 901
3 0 0 1 1 902
4 0 1 0 0 903
5 0 1 0 1 904
6 0 1 1 0 905
7 0 1 1 1 906
8 1 0 0 0 907
9 1 0 0 1 908
101010909
111011910
121100911
131101912
141110913
151111914
※ For auto design call, an internal memory or a diskette must have the patterns from #900 to #906 saved.
 Definition and explanation of external input ports
The auto call cable is an optional item.
Please request the item when the function will be used.
Caution
Name Input Port Connector Explanation
SEN_0 IP4.0 CN22
SEN_1 IP4.1 CN22
SEN_2 IP4.2 CN22
SEN_3 IP4.3 CN22
Clamp IP4.4 CN22 Clamp drive signal (low active)
Emergency S/W IP4.5 CN22 Emergency stop switch signal (low active)
Sewing Start IP4.6 CN22 Sewing start signal (low active)
Enter Key IP4.7 CN22 Ready signal (low active)
Sensor connection for auto call function
(low active)