SunStar SPS/A-Pattern Series - Page 185

185
※ Connect the RA2611 connector of the auto call function cable to CN22 on the I/O board.
▶
See the 'Description on connector and jumper pin locations' below regarding the connector locations on the
I/O board.
▶ See the cable specifications for cable connectors.
※ A total of 8 adjacent cables are used. Please request the desired number of adjacent sensor cables.
Cable name Product No. Cable connecting position
(SPS/B, A-Series) Auto call function cable
Adjacent sensor cable
CA-003043,00Ä
CA-002857,00
CN22 on the I/O board
SMR-03V-N of the auto call function cable
 Cables connected by user
 Cable signal input information
1 +5V or +24V BR1
SEN_0 2 SEN_0
3 GND
1 +5V or +24V BR2
SEN_1 2 SEN_1
3 GND
1 +5V or +24V BR3
SEN_2 2 SEN_2
3 GND
1 +5V or +24V BR4
SEN_3 2 SEN_3
3 GND
1 +5V or +24V BR5
CLAMP 2 Clamp driving signal
3 GND
1 +5V or +24V BR6
EM-STOP 2 Emergency stop signal
3 GND
1 +5V or +24V BR7
START 2 Signal line for sewing start signal
3 GND
1 +5V or +24V BR8
ENTER 2 Signal line for ready signal
3 GND
Signal name
Connector pin number
(SMR-03V-N)
Description
Jumper pin for voltage
change