SunStar SPS/A-Pattern Series - Page 186

186
 Connector and jumper pin position
Connector and jumper pin position on I/O board
 Connector for signal input (CN 22) Connecting the auto call function cable (connector: RA2611)
 Jumper pin for changing signal input power
No. Description Remarks
 Changing jumper for sensor input power change
▶ The input power supply to the sensor can be altered to +5V / +24V by changing the BR jumper at the upper left side
of the I/O board.
The auto call function uses the adjacent sensor. Therefore connect the jumper pin to No. 2 and No. 3.
(Jumper pins for change: BR1, BR2, BR3, BR4, BR5, BR6, BR7, BR8 )
When changing the sensor specifications depending on the user needs, change the input power supply.
Caution