SunStar SPS/A-Pattern Series - Page 187

187
Signal name Input port Connector Description
SEN_0 IP4.5
SEN_1 IP4.6
SEN_2 IP4.7
Clamp IP3.4 Signal for clamp drive (low active)
Emergency S/W IP3.5 Signal for emergency stop switch (low active)
Sewing Start IP3.6 Signal for sewing start (low active)
Enter Key IP3.7 Ready signal (low active)
CN16
Sensor input
connector
Sensor connection for auto call function (low
active)
Description：This is a function to call designs automatically. A total of 15 designs can be automatically called by using the
four input sensors. It can be controlled by external inputs such as sewing start, emergency switch, clamp, and the enter key.
▶ The description below is related to 5050 and 8050.
1-1) Signal information related to input port connection
How to Use AUTO CALL (For SPS/C-5050,8050)
 External sensor's input signal list-up for design auto call
NO. SEN_2 SEN_1 SEN_0 Design Number
1 0 0 1 900
2 0 1 0 901
3 0 1 1 902
4 1 0 0 903
5 1 0 1 904
6 1 1 0 905
7 1 1 1 906
※ For design auto call, pattern numbers from 900 to 906 should be saved in the internal memory or USB flash drive.
 Definition and description of external input ports
The auto call cable is an optional item.
Please request the item when the function will be used.
Caution