SunStar SPS/A-Pattern Series - Parameter Save Function; Saving Parameters to USB

194
This function enables user to save user-defined parameter data in external storage devices (USB) while using the
pattern device.
The parameter data saved in external storage devices (USB) can be used to replace the current parameter data all
the time.
1) Parameter Write
This is how to save changed parameters in line with user setting in external storage device.
The procedures are as follows:
A. Press the MODE key on the initial screen and select
Initialize on the main menu.
B. Select No.3 Ptrn Para.
Then the Select Mode screen is displayed.
To write parameter data, select 0. Write.
C. Select 0 on the keypad.
D.
Ready LED blinks, and the device's data is saved in
the external storage device (USB).
Data is automatically saved in the set route as
below:
USB route) A:\\SPS\\PARA
<< Main Menu >>
0. Initialize
1. Parameter Set
2. Program
<< Initialize >>
1.Para. Init
2.Sys. UpData
3.Ptrn Para
<< Select Mode >>
Write(0)
Read(1)
To Exit(ESC)...
Parameter save function
When using the parameter data saved in external storage device (USB), the parameter data of the current device is
replaced with the parameter data of external storage device (USB).
Caution
99