195
2) Parameter Read
This is how to replace the revised parameter data in the pattern device with the parameter data saved in the external
storage device. The procedures are as follows.
The procedures are as follows:
A.
Press the MODE key on the initial screen and select
Initialize on the main menu.
B. Select No.3 Ptrn Para.
Then the Select Mode screen is displayed.
To read parameter data, select 1. Read.
C. Select No. 1 on the key pad.
D.
Ready LED blinks, and the parameter data saved in
the device is replaced with the parameter data saved
in the external device (FDD).
<< Main Menu >>
0. Initialize
1. Parameter Set
2. Program
<< Initialize >>
1.Para. Init
2.Sys. UpData
3.Ptrn Para
<< Select Mode >>
Write(0)
Read(1)
To Exit(ESC)...
To Previous Page
Loading...
