34
D. After pressing READ key, input the pattern
number to move and change partial pattern
data by using digit key and read in the pattern
by pressing ENTER key. (For example, input
[0][0][1] to read the pattern number 001.)
E. Go to the needle location to partially move by
using FORW and BACK key.
014:PTRN READ
NO :001
JUMP
X:00174A N:00070
Y:00183A
Function Code?
Reference) Location of the needle for partial movement
should be placed at the first start needle location that
actually sews. Therefore, if the sewing data that has
line property after jump appears, the last location of
JUMP data is the first start location of needle correction.
F. After pressing CODE key, if you know the
function number related to pattern programming,
input three figure digit number 046, but if you
do not know the number, press ENTER key.
Then after move to “046:MOV PTRN” by
using direction key , press ENTER key.
<Function Code>
046:MOV PTRN<
052:COPY PTRN
053:DEL PTRN
G. Go to the last location of pattern to move by
using FORW key.
※ The indicated values are different according
to current location.
<RANGE SETTING>
X:00174A N:00088
Y:00183A
H. If you press EXE key, it becomes the state
that the selected pattern for partial movement
can move to the optional location.
046:MOV PTRN
X:00174
Y:00183
N:000
I. Move to the location to move by pressing direction
key.
046:MOV PTRN
X:00174
Y:-0101
N:000
J. If you press EXE key, movement is completed.
K. Confirm if movement was properly made by
using FORW and BACK key.
LINE
X:00174A N:00096
Y:-00101A
Function Code?
To Next Page
Loading...
