SunStar SPS/A-Pattern Series - Page 46

46
(4) Saving as New Pattern Number
A. After pressing WRITE key, input the number
you want to save by using digit keys. then
press ENTER key. Save the generated pattern
data in a USB flash drive as a relevant number.
(For example, if you want to save the pattern
number as 550, input [5][5][0].) During saving
the pattern, the READY LED flickers.
When a pattern of same number is in a USB
flash drive and if you want to save another
pattern as same number, press ENTER key. If
you want to save the pattern as another
number, press ESC key and save it as another
number.
After finishing saving, the READY LED turns
off, the upper feed plate moves to the origin
again.
B. For finishing pattern generation, press MODE
key. Then the upper feed plate moves to the
origin and ascends. Press ESC key to back to
the initial screen.
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
015:PTRN WRITE
NO :550
Pattern Exist!
OverWrite?
Y(ENTER)/N(ESC)
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
<< Main Menu >>
2. Program
3. Bobbin Wind
4. Machine Test
B. By pressing TEST key, complete the test sewing.
The upper feed plate descends and moves to the
origin, then READY LED turns off.