SunStar SPS/A-Pattern Series - Page 47

47
3-2-2) Changing the Sewing Speed by Making New Pattern Data
<< Main Menu >>
2. Program
3. Bobbin Wind
4. Machine Test
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
004:JUMP
X:-0650
Y:00300
N:001
JUMP NONE
X:-0650A N:00065
Y:00300A
Function Code?
A. Insert a USB flash drive into the terminal.
B. Press MODE key.
C. By using direction keys , move to “2.
Program” menu, then press ENTER key. At
this time the upper feed plate descends, and
moves to the origin.
D. After pressing JUMP key, move to the initial
point of square by using direction keys, then press
PNT SET key.
E. By pressing EXE key, the feed plate moves
according to the operated pattern data after
operating the data.
F.
After pressing LINE key, input the stitch width
by using digit keys, then press ENTER key.
(For example, if you want to set up the stitch
width as 3mm, input [0][3][0].)
(0,0)
(JUMP)
P4
P3
P2
P1
2000spm 2000spm
500spm
2000spm
Line
2000spm 2000spm
R1
R2
007:LINE
WIDTH:030[0.1mm]