SunStar SPS/A-Pattern Series - Page 48

48
007:LINE
X:00360
Y:00300
N:001
LINE NONE
X:00360A N:00099
Y:00300A
Function Code?
LINE
X:-0350A N:00075
Y:00300A
Function Code?
<Function Code>
CODE No : 012
012:STI SPD
STSPM:05[100spm]
G. By using direction keys, move to the end point(R2)
of section that the sewing speed is supposed to
change and press PNT SET key.
H.
By pressing EXE key, the feed plate moves
according to the operated pattern data after
operating the data.
I. By using FORW, BACK keys, move to the
start point (R1) of section that the sewing
speed is supposed to change.
J. After pressing CODE key, input the three digit
numbers if you know the pattern programming
related function code, but if you don’t know it,
press ENTER key and move to “012. STI
SPD”by using direction keys , then press
ENTER key.
K. By using digit keys, input the sewing speed you
want to change, then press ENTERkey.
(For example, if you want to change the speed
into 500spm, input [0][5])
L. By using FORW, BACK keys, move to the end
point (R2) of section that the sewing speed is
supposed to change.
Then after pressing PNT SET key, press EXE
key.
<RANGE SETTING>
X:00360A N:00099
Y:00300A
Function Code?