55
C. If you press ENTER , you can get the screen
like a figure on the right side, then input [0][6][3].
※ Appendix :
Refer “Parameter number related to general sewing.”
D. After pressing ENTER key, decide whether
you use extension/reduction or not by using
direction keys .
Here set we “2)STITCH_LEN: Extension/
Reduction by stitch length”.
E. Press ENTER key.
Press ESC key to back to the initial screen.
A. Press X SCALE and set the rate you want. For
example, if you want to reduce 70%, input [0][7][0].
B. Press Y SCALE and set the rate you want. For
example, if you want to reduce 50%, input[0][5]
[0].
<Parameter Set>
PARA No : 063
063:Scale MODE
1) DISABLE
2) STITCH_LEN <-
3) STITCH_NUM
<< Main Menu >>
1. Parameter Set
2. Program
3. Bobbin Wind
NO:001 NOR_SEW
XS:070%
YS:100% SP:2000
BC:000 PC:0000
NO:001 NOR_SEW
XS:070%
YS:050% SP:2000
BC:000 PC:0000
(2) Setting the Rate for Extension/Reduction
C. Press NO key and input the pattern number by
using digit keys. (For example, if you want to
work with “001”pattern, input [0][0][1].)
D. Press ENTER key to read patterns and to be
sewing available mode.
NO:001 NOR_SEW
XS:070%
YS:050% SP:2000
BC:000 PC:0000
To Next Page
Loading...
