SunStar SPS/A-Pattern Series - Page 54

54
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
015:PTRN WRITE
NO :552
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
<< Main Menu >>
2. Program
3. Bobbin Wind
4. Machine Test
B. By TEST key, complete the test sewing.
The upper feed plate descends and moves to the
origin, then READY LED turns off.
(4) Saving as New Pattern Number
A. After pressing WRITE key, input the number
want to save by using digit keys. then press
ENTER key. Save the generated pattern data
in a USB flash drive as a relevant number. (For
example, if you want to save the pattern
number as 552, input [5][5][2].) During saving
the pattern, the READY LED flickers. When
finishing the save, the READY LED turns off,
and the upper feed plate moves to the origin
again.
B. For finishing pattern generation, press MODE
key. Then the upper feed plate moves to the
origin and ascends. Press ESC key to back to
the initial screen.
3-4) Using the Extension/Reduction Modes
It is used when you want to extend or reduce the already programmed sewing patterns, and you should
be careful not to exceed the transfer limit during the setting for rate of extension/reduction. You can
extend or reduce with STITCH_LEN by the stitch width, and with STITCH_NUM by the numbers of
stitches. To use these functions, the parameter number related to general sewing, “053. Extension/Reduction
mode”should be set to “2)STITCH_LEN”or “3)STITCH_NUM”.
(1) Setting the Extension/Reduction Mode
A. Press MODE key.
B. Move to “1. Parameter Set” by using direction
keys .
<< Main Menu >>
1. Parameter Set
2. Program
3. Bobbin Wind