SunStar SPS/A-Pattern Series - Page 53

53
015:PTRN READ
NO :500
007:LINE
X:-0300A N:00085
Y:00000A
Function Code?
<Function Code>
CODE No : 049
049:REV SET
POS : 1[0/1]
REV SET NONE
X:-0300A N:00084
Y:00000A
Function Code?
<Test Sewing>
SP:1200
D. After pressing READ key, input the pattern
number that sewing speed is supposed to change,
then press ENTER key to read the pattern.
(For example, input [5][0][0] to read pattern
number 500.)
(2) Inserting the Code for Reversal
A. By using FORW, BACK keys, move to the
point P4 that you want to add code for
reversal.
B. After pressing CODE key, input an order for
reversal by pressing digit keys, [0][4][9].
C. Press ENTER key.
After pressing digit key, 1, and operate the
reversal cylinder by pressing ENTER key.
D. After checking for sure, input the code for
reversal once again by pressing ENTER key.
(3) Test Sewing
A. Press TEST key.
After moving to the origin, the upper feed plate
moves to the sewing start point, then ascends
and the READY LED turns on. After adjusting
the proper test sewing speed by pressing SPEED
key, if you press down once the foot plate on
the right side, the upper feed plate descends,
and if press down once the plate on the left
side, the test sewing is performed.
After completing the test sewing, the upper feed
plate moves to the sewing start point, then
ascends.