SunStar SPS/A-Pattern Series - Page 52

52
TRIM NONE
X:00020A N:00105
Y:00280A
Function Code?
004:JUMP
X:-0100
Y:00280
N:001
JUMP NONE
X:-0100A N:00115
Y:00280A
Function Code?
015:PTRN WRITE
NO :551
Q. By pressing TRIM key, input the code for trim.
“000:TRIM”appears on the screen for a while,
then replace it with the screen of the right side.
R.
After pressing JUMP key, move to the B point
by using direction keys.
Then press PNT SET key.
S. By pressing EXE key, the feed plate moves
according to the operated data after operating
the pattern data.
T. Perform test sewing.
U.
After pressing WRITE key, input the number
you want to save by using digit keys. then
press ENTER key. Save the generated pattern
data in a USB flash drive as a relevant number.
(For example, if you want to save the pattern
number as 551, input [5][5][1]).
V. For completing the pattern generation, press
MODE key. The upper feed plate moves to
origin and ascends. By pressing ESC key, back
to the initial screen.
<< Main Menu >>
2. Program
3. Bobbin Wind
4. Machine Test
<< Main Menu >>
2. Program
3. Bobbin Wind
4. Machine Test
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
3-3-2) Adding the Code to Already Programmed Pattern
(1) Reading the Pattern that does not have Code
for Reversal
A. Insert a USB flash drive holding a pattern that
you want to add.
B. Press MODE key.
C. By using direction keys , move to “2.
Program” menu, then press ENTER key. At
this time the upper feed plate descends, and
moves to the origin.