SunStar SPS/A-Pattern Series - Page 51

51
007:LINE
WIDETH:030[0.1mm]
007:LINE
X:-0300
Y:00000
N:003
LINE NONE
X:-0300A N:00082
Y:00000A
Function Code?
<Function Code>
CODE No : 049
049:REV SET
POS : 1[0/1]
REV SET NONE
X:-0300A N:00083
Y:00000A
Function Code?
007:LINE
X:00020
Y:00280
N:002
J. After pressing LINE key, input the sewing
width by using digit keys, then press ENTER
key.(For example, if you set up the stitch
width as 3mm, input [0][3][0].)
K.
Move to P2, P3, P4 by using direction keys, then
press PNT SET to input coordinates of each
edge.
L. By pressing EXE key, the feed plate moves
according to the operated data after operating
the pattern data.
M.
After pressing CODE key,
input an order for reversal by pressing digit
keys, [0][4][9].
N. Press ENTER key.
After pressing digit key 1, press ENTER key to
operate the reversal cylinder.
O. After checking for sure, input the code for
reversal once again by pressing ENTER key.
P. By using LINE key, make program the other
two points, P5, P6