SunStar SPS/A-Pattern Series

To Next Page

To Previous Page

D. Move to and press key in order to use this function

ENTER2)ENABLE

C. When choosing, is set at

: After trimming, don’t use the

reverse rotation function after

trimming.

: After trimming, use the reverse

2)ENABLE

1)DISABLE

086. RevAfterTrim

086.RevAfterTrim

1) DISABLE

2) ENABLE <

3-21) Setting Reverse Rotation after Trimming [Only applied for SPS/B/C-Series]

Function of Reverse rotation after trimming is as follows. When sewing material is thick, the thick material

can interfere with needle if the needle is placed at the highest point of thread take-up. In that case, the

interference will be prevented if the needle is placed in reverse order. Therefore, after trimming, set the

point of reverse rotation as the applicable angle by using the reverse rotation function. If sewing material is

not thick, don’t use the function.

Setting method is as follows.

<< Main Menu >>

1. Parameter Set

2. Program

3. Bobbin Wind

A. Choose Parameter Set from Main Menu by pushing

key.

MODE

< Parameter Set >

086. RevAfterTrim

087. ReverseAngle

088. Oil Control

B. Choose from Parameter Set by

using keys .

direction

086. RevAfterTrim

SunStar SPS/A-Pattern Series - Page 79