SunStar SPS/A-Pattern Series - Page 81

81
3-23) Setting Output Port [Only applied for SPS/C-Series]
The function is that a user can program devices that are set to certain places when punching. The list of
the devises is as follows.
NO Device
Content
00 PF Presser Feet
01 FF Feed Plate
02 TT Trimming
03 TH Thread Holder
04 WP Wiper
05 FF_L Left Feed Plate
06 TWO_STG Two-Step Stroke Feed Plate
07 REV_DEV Inverting Device
08 REAR_FF Rear Feed Plate
09 TR Thread Release
10 AFC Material Conveying Pressing Device
11 TR3 Thread Release 3
12 HEAD Machine Head
13 OP55~OP57 Other Ports [Don’t use]
14 OP60~OP67 Other Ports [Don’t use]
Line 1
Line 3
Line 4
TR3 : ON
Line 2
TR3 : OFF