98
Method 2: Setting by saving pattern stored in internal memory into USB flash drive.
A. Insert the USB flash drive stored designs into
the terminal.
B. Input pattern number you wish to read from the
initial screen, and press Enter to read design.
C. With READY LED activated on OP box, press
Enter to turn off READY.
D. Press B. SET bobbin counter button in the initial
screen to set the desired value of bobbin counter.
E. Click WRITE save button in the OP box to
save onto USB. Re-write under the same name,
or save under a different name.
F. New value of bobbin counter will be saved in
design
NO:003 NOR_SEW
XS:100%
YS:100% SP:2000
BC:100 PC:0000
NO:003 NOR_SEW
XS:100%
YS:100% SP:2000
BC:005 PC:0000
015:PTRN WRITE
NO :002
To Next Page
Loading...
