SunStar SPS/A-Pattern Series - Page 99

99
A. Press the MODE key to move to the Parameter
Set of the Main Menu.
B. Press Enter and move to 090. Save Type.
<< Main Menu >>
1. Parameter Set
2. Program
3. Bobbin Wind
<Parameter Set>
090.Save Type
091.DsgnOpnCtrl
092.Safty Mode
4-10) Saving in the Internal Memory after Creating Pattern Designs
Previously, users are required to save pattern designs, which are created with OP, in FDD only.
However, the added function can allow them to save the pattern designs in the internal memory.
Users can choose the place of storage from the parameter menu following the direction below.
Setting method is as follows.
C. The default value is set at 1) SAVE USB,
which is a previously used method.
090:Save Type
1) SAVE USB <-
2) SAVE FLASH
D. Move the cursor to 2) SAVE FLASH to save
the patterns in the internal memory and press
Enter .
E. Since the setting is complete, when users save
the pattern designs created using OP, they will
be saved in the internal memory (Flash
Memory), not in USB.
090:Save Type
1) SAVE USB
2) SAVE FLASH <-
F. Return to the main screen and press the number
of saved pattern and then Enter . The
concerned pattern design will be read for sewing.
NO:003 NOR_SEW
XS:100%
YS:100% SP:2000
BC:100 PC:0000