8
When the machine needs to be repaired, it shall be mended only by designated A/S
engineers who have completed training courses of SunStar.
ⓐ Cut off the power supply before cleaning or repairing the machine. After power
shut-down, wait for four minutes until electricity is completely discharged from
the machine.
ⓑ Without discussion with SunStar, modifying the specifications of the machine or
any parts is not allowed. Arbitrary change of the machine could cause dangers
during operation.
ⓒ Use the spare parts produced by Sunstar for repairing.
ⓓ Put safety covers which are removed for repair back to the machine after the
repairing is done.
4) Repair
Caution
5) Safety Devices
ⓐ Safety label : Cautions during machine operation.
ⓑ Motor cover:
Prevents potential accidents which might occur during motor operation.
ⓒ Inside thread supplier cover :
Prohibits fingers and the inside thread supplier from contacting each other.
ⓓ Finger guard: Prohibits fingers and needle from contacting each other.
ⓔ Safety plate: Prevents broken needle from injuring eyes.
ⓑ
ⓓ
ⓔ
ⓐ
ⓒ
To Next Page
Loading...
Need help?
General
