SunStar SWF/C Series - 7-4-13) NEEDLE BAR SELECTION

7-65
Set X=600, Y=1500 using key
and press
X : 0, Y : 0
=== MIDDLE OFFSET ===
=> FRAME MOVE
=== OFFSET POINT ===
=> FRAME MOVE
7-4-13) Needle Bar Selection
Press when the operating system loads and you will see a screen like this:
This sets the automatic color changing functions and the needle bar order.
[NOTE]
You can set up to a 99th needle in the needle bar order.
Input “0”and the set-up data will be deleted.
==== NEEDLE SELECT ====
[1 ]: 1 / 1
[END] [INSERT] [DEL]
Set X=800, Y=2000 using key
and press