7-27
Press DOWN once.
Press
7-4-3) Auxiliary Work
Press when the machine is turned on and the operating system loads. You will see a screen like this:
These menus help you prepare before starting embroidery work.
1. LENGTH MEASURE: measures the length between two selected points.
2. DESIGN TRACE: checks the outline area of the selected design.
3. OPTIMIZE TRACE: traces the shape of the selected design.
X[mm] : 96.5
Y[mm] : 135.0
ANGLE : 45
MIRROR : OFF
The X and Y lengths changed and the Angle is
set at 45 degrees.
Machine Information Screen shows 100 stitches
progressed already.
100/18294 st[ 0%]
1. LENGTH MEASURE
2. DESIGN TRACE
3. OPTIMIZE TRACE
To Next Page
Loading...
Need help?
General
