5-5
① START/STOP for starting embroidery and stopping the machine
[NOTE 1]
“Inching”refers to low-speed embroidery at a 100 rpm range, performed for stable stitching when the
machine is re-started after stop.
[NOTE 2]
“Frame movement unit”refers to the “BKSTITCH UNIT”in “EMB FUNCTION.”You can select from 1 to
10 stitches (by 1 stitch).
④ START /STOP during backward non-stitching (during machine stop)
See ② START/STOP during machine stop.
⑤ Performing Work Other Than Embroidery
If you want to perform a solenoid test, a thread break sensor test, or manual trimming, select the function and
press START.
③ START/STOP during forward non-stitching (during machine stop)
Refer to “7-4-8) Float (Non-Stitching) Functions.”
BUTTON OPERATION
Press START
Hold START
Press START Again
Frame moves forward in selected movement units (see Note 2)
Frame starts to move forward.
If you press START before the machine goes 10 of the selected stitches,
the machine will stop immediately (the machine moves back in the selected
movement units). If you press START after the machine traveled 10 of the
selected stitches, the machine will continue to move forward.
Press START one more time and the machine will stop moving forward.
MACHINE OPERATION
② START/STOP during machine stop
BUTTON OPERATION
Press STOP
Hold STOP
Press STOP again
Frame moves backward in selected movement units (see Note 2).
Frame starts to move backward.
If you press STOP before the machine goes 10 of the selected stitches,
the machine will stop immediately (the machine moves back in the
selected movement units).
If you press STOP after the machine traveled 10 of the selected stitches,
the machine will continue to move back.
Press STOP one more time and the machine will stop moving backward.
MACHINE OPERATION
[NOTE 1]
You cannot perform non-stitching (floating) at the start of the embroidery because the function is not in the
start menu. To perform floating at the start, press STOP to put the machine in STOP MODE. Then press
button to select the non-stitching function.
BUTTON OPERATION
Press START
Hold START
Press STOP
Machine starts and embroidery work begins.
Machine “inches (see Note1)”until you release the button.
Machine stops.
MACHINE OPERATION
Select function Press START
To Next Page
Loading...
Need help?
General
