7-31
■■
Optimize Trace
① This enables you to quickly check the outline of the selected design by tracing the outline.
② The arrows in the picture show the path of the trace. The design will be traced at its furthest points. If it is too
large for the hoop, the frame stops and the message “Frame Limit Error”will appear on the screen. To use this
function, select and in the start menu to set the frame
limits and set to “YES”in the EMB FUNCTION.
15. Frame Limit
3. Frame Limit Set2. Machine SETMachine Set-Up
To Next Page
Loading...
Need help?
General
