SunStar SWF/C Series - Page 79

7-35
Input “40”for X design interval and
press
Input “1”to select X as priority and
press
For design interval, press UP a few
times.
Use the cursor to go to the next
screen.
==== REPEAT SETTING ====
4] Y Design Interval
-300
-
> +300[mm]
=> ( 0)
==== REPEAT SETTING ====
4] Y Design Interval
-300
-
> +300[mm]
=> ( -40)
==== REPEAT SETTING ====
5] Y/X Priority
Y(0), X(1)
=> ( Y)
==== REPEAT SETTING ====
6] Design Interval
JUMP(0), STOP(1)
=> ( JUMP)
You can check or change the set-up data. The
data in the brackets is the set-up data.
Input “–40”for Y design interval and
press