To Next Page

To Previous Page

7-38

④ AUTO ORIGIN

This move the frame back to the start position after work is finished. The default is “YES.”Select “0”for “NO”

if you do not want to use this function.

⑤ START INCHING

The machine inches slowly when it starts. You can set up the number of stitches to inch. The default is 2 stitches

and the range is between 0 and 5 (in the increments of 1 stitch).

⑥ TRIM INCHING

The machine inches slowly when it detects a signal for color change or finishes embroidery for one design. You

can set up the number of stitches to inch. The default is 3 stitches and the range is from 2 to 5 (in the increments

of 1 stitch).

⑦ AUTO JUMP

The machine automatically changes to JUMP CODE if the interval between the two stitches is longer than the set-

up data. You can set the standard number of stitches for the automatic change to JUMP CODE. The default is

10.0mm and the range is between 5.0mm and 12.7mm in the increments of 0.1 mm.

⑧ BK_ST UNIT

This sets the number of stitches to be made at a single bar switch action when you do forward or backward

stitching using the bar switch. The default is 1 stitch and the range is 1-10 stitches in the increments of 1 stitch.

⑨ BK_ST START

When you moved the frame back from the stopped position to work with a bar switch, you can set whether the

stitching will start automatically. The default is “YES”and you can select “0”for “NO.”

⑩ BK_ST ALL

When you moved the frame from the stopped position and start embroidery with a bar switch, you can set

whether only the head with a broken thread will operate or all heads will operate. The default is “EACH (single)”

and you can input “1”to select “ALL.”

⑪ TRIM START

You can set whether embroidery work will start automatically after trimming by JUMP CODE, TRIMMING, and

STOP CODE. The default is “YES”and you can select “0”to set at “NO.”

(Automatic start after trimming)

(Previous needle bar operation after back stitching)

(Automatic start after back stitching)

(Back stitching unit)

(Interval of automatic jump stitches)

(Number of inchings after trimming)

(Number of inchings at the beginning)

(Return to the start position)

SunStar SWF/C Series User Manual

Questions and Answers: