5-2
⑦ Number Buttons
This is used to input numbers when setting parameters.
⑧ STOP Button
Stops the machine or performs reverse work
⑨ START Button
Starts the machine
⑩ Frame Movement and Speed Button
Moves the frame left, right, up, and down. Press the lamp key in the center to set the speed of the frame move
to low, medium, or high.
⑪ Main Shaft Speed Button
Changes the speed (by unit of 10 rpm) of the main shaft during operation. Press [UP] to increase and [DOWN]
to decrease the speed.
⑫ ./ALL Button
You can use this to input decimal numbers when setting the interval of repetition work. It can also be used to
work on the previous head after back stitching.
[NOTE]
function
Selects menu
Sets number inputs
Completes work:
When the machine stops during operation, hold [SET] key until you hear a loud beep. The machine will
complete the work (Press [SET] until the RUN MODE indicator light is turned off).
[CAUTION]
CHANGING NEEDLE BAR WITH [SET] KEY
If you want to change the needle bar during operation, press number key and then [SET].
To Next Page
Loading...
